Setup work - Safety instructions
9 - 1
830 / 07.2012
Original operating instructions
9 Setup work
9.1 Safety instructions
DANGER
The work performed may only be completed by trained and
instructed specialists.
Wear personal protective equipment (e.g.protective helmet, ear
protection, protective gloves, safety shoes) where working
conditions require. At working heights of 2.00 m or more,
SENNEBOGEN recommends the use of a safety harness to prevent
falling.
The following applies for all setup work:
Only carry out the work if the work area has a firm, even subgrade that
is solid enough.
Ensure that there is no one in the danger area.
– While setting up, and before completing all fastening work, no
persons are allowed in the hazardous area in which loads could fall
or under hanging loads.
– During the setup procedure, keep a sufficient safety clearance
from areas of unavoidable cutting or pinching/crushing danger.
Observe the relevant accident prevention regulations for working
with hoisting accessories.
When dismantling components or disassembling equipment, always
use hoisting accessories with a sufficient safe working load.
Suspend components only with the designated lifting brackets.
Do not step on equipment that is not designed for it (e.g. parts of the
boom or ballast), hanging on a crane.
Carry out all setup work in sequence. Never carry out more than one
setup task at a time.
Note
The setup work to be carried out depends on the selected attachment
tools. Observe the notes in the operating instructions of the tool
manufacturer.
To Next Page
Loading...