Safety - Safety instructions
1 - 21
07/2012
Original operating instructions
1.9 Safety instructions
1.9.1 General
Danger area The danger area is the area around the machine where persons may
come into contact with:
machine motions while in operation
working equipment and its attachments
swinging out or dropping loads
dropping working equipment.
DANGER
No persons may be within the danger area!
The machine operator must issue warning signals where persons are
endangered. If the persons do not leave the danger area despite the
warning, work must be stopped.
To avoid becoming crushed by solid objects, e.g. building structures,
walls to be removed, scaffolding or other machinery, a sufficient safety
distance (at least 500 mm) must be maintained.
If the safety distance cannot be maintained, the area between the solid
structures and the work area of the machine must be cordoned off.
If the machine operator has restricted driving and working vision, then
he must be guided.
Personal
Safety equipment
While working on the machine, operating personnel are obliged to wear
personal safety equipment (e.g. safety helmet, ear protection,
protective gloves, safety boots) as laid down by national regulations.
Eye bolts are installed as safety eyelets on the upper structure. The
safety eyelets are used for hanging a safety belt to protect personnel
from falling from the machine. At working heights of 2.00 m or more,
SENNEBOGEN recommends the use of a safety harness to prevent
falling. At working heights above 3.00 m, using a safety harness is
required legally.
Hanging rings are marked.
To Next Page
Loading...