sennebogen 830 E - Fitting the step grip on the cab

Setup work - Fitting the step grip on the cab
9 - 3
830 / 07.2012
Original operating instructions
9.2 Fitting the step grip on the cab
Note
Observe the safety instructions in C
HAPTER 1 SAFETY.
DANGER
Danger to life from crashing cab
 The step grip on the cab must be assembled/disassembled by
trained and instructed technicians only!
 Always replace any fixing bolts after disassembly, do not reuse.
 Components are to be tested by specialists before reusing and
replaced if necessary.
 Use only original SENNEBOGEN spare parts.
1 Carefully raise the step grip (1) to the cab using suitable
equipment.
2 Screw the step grip to the frame (2) (observe torques, see
Kapitel 3.11 A
NZIEHDREHMOMENTE FÜR SCHRAUBEN).
3 Check the step grip is properly secured.
2
1