sennebogen 830 E - Checking the Refrigerant Level

Start-up - Checking the swing gear fill level
4 - 20
830 / 07.2012
Original operating instructions
4.7.4 Checking the refrigerant level
WARNING!
Danger of injury from scalding!
Inspect only when the cooling system has cooled.
Checking the refrigerant
level and antifreeze
Note
Pay attention to the information in the maintenance instructions.
1
1 Allow the drive engine and cooler to cool down.
2 Place large, thick cloths on the sealing cap (1) of the refrigerant
expansion tank and open it carefully in order to equalize the
pressure.
3 Check the antifreeze and coolant level, top up if necessary.
Mixing ratio: 50% antifreeze, 50% water. Frost resistance to
- 37°C (- 34°F).
4 Re-close the expansion tank sealing cap (1).