sennebogen 830 E - Working loads

Technical data - Working loads
3 - 6
830 / 07.2012
Original operating instructions
3.5 Working loads
Information
The load ratings
 Are specified in tons (t) and equate to 75% of the static tipping load
or 87% of the hydraulic lifting force according to ISO 10567.
 Are applicable for a machine on firm, level ground and apply over a
range of 360 degrees.
 Apply when the machine's supports are deployed.
Hoisting accessories (grabs, hooks, equalizers etc.) are part of the
lifting capacity.
Deduct the weight of the hoisting accessories (hooks, sling) from the
lifting capacities. The values in parentheses apply in a direction along
the lengthwise axis of the undercarriage.
Adverse
conditions
Limit or reduce the load ratings to compensate for adverse conditions.
Adverse conditions are e.g.
 Soft or uneven ground
 Slopes
 Wind
 Lateral loads
 Rocking loads
 Jerking or sudden stopping of load
 Inexperience of operating personnel
 Driving with load
Note
Before changing the kinematic position please contact SENNEBOGEN!
Setup conditions The machine has two setup conditions:
– Without outrigger
– With outrigger
The load ratings apply to supported operation/setup condition. The load
must be deposited when changing between the setup conditions.
Danger
Changing setup conditions with a raised load can lead to a loss of
stability of the machine. This can in turn result in severe damage to
property and to personal injuries.