Safety - Supplementary and operational equipment
1 - 14 07/2012Original operating instructions
1.8 Supplementary and operational equipment
1.8.1 SENNEBOGEN CONTROL System (SENCON)
Note
Sensors monitor the current operating status of the machine and transmit
the measurement results to the SENCON. The measurement results are
evaluated in the SENCON and displayed automatically or at the push of
a button on the unit. The indicator and warning lamps are activated if
irregularities occur on the machine.
Correct a minor fault condition (clogged air filter, empty fuel tank or the
like) by yourself without delay.
Contact SENNEBOGEN Customer Service to correct a more serious
irregularity (one that you cannot correct yourself)
SENNEBOGEN
CONTROL System
Note
Further information on SENCON can be found in Abschnitt
5.4 SENNEBOGEN CONTROL S
YSTEM (SENCON).
CAUTION
The SENNEBOGEN CONTROL system must never be cleaned with
cleaning agents containing alcohol or solvents. Failure to observe the
above could result in damage to the plastic surface.
To Next Page
Loading...