sennebogen 830 E - Safety; General information

Safety - General information
1 - 1
07/2012
Original operating instructions
1 Safety
1.1 General information
The machine is built to state of the art standards. Nevertheless, there
may be dangers during its use to persons, machines and other
property, if
 the machine is not utilized in accordance with its intended use
 The machine is not operated or maintained by trained personnel
 the safety instructions are not observed.
 the machine is found to be defective.
 the attachment tools attached do not comply with the relevant safety
regulations.
 The attachment tools attached are found to be defective.
National and international regulations apply in addition to the safety
instructions in these instructions.
In the Federal Republic of Germany e.g.:
 Winches, Lifting and Pulling Equipment (TUR D8)
 Cranes (TUR D6)
 Crane inspections (BGG 905)
 EU Machinery Directive 2006/42/EC
 EMC Directive 2004/108/EC
 Electrical Equipment in Machines (EN 60204-1)
 Safety Requirements for Fluid Power Systems and their
Components — Hydraulic Systems (EN 982)
 Earth-Moving Machinery — Safety (EN 474-1/-5)
 Safety of Machinery (DIN EN 12100-1 and DIN EN 12100-2)
 “Outdoor” guideline 2000/14/EC and 2005/88/EC
Note
If national regulations in the country of operation deviate from our
recommendations, the more stringent procedure should be followed.