Safety - Supplementary and operational equipment
1 - 16 07/2012Original operating instructions
1.8.4 Engine oil
SENNEBOGEN factory filling for engine oil is selected for use with
sulfur-free diesel fuel with a sulfur content of <15mg/kg.
Note
The use of low ash engine oils per specification ACEA E9-08 or API CJ-4
is strictly specified for engines of exhaust level EU stage IIIB and US EPA
level 4 interim.
Observe the notes in the engine manufacturer operating instructions.
CAUTION
Using engine oils of a specification different than ACEA E9-08 or API
CJ-4 causes damage to the exhaust gas treatment system for engines
of exhaust level EU stage IIIB and US EPA level 4 interim. This can
invalidate the emission certification of the diesel engine and have legal
consequences for the operator.
Note
The use of engine oils with a specification other than ACEA E9-08 or
API CJ-4 is permissible for engine of exhaust level EU stage II or IIIA
and US EPA level 2 or 3.
Observe the notes in the engine manufacturer operating instructions.
WARNING
Mixing oils, lubricants or operational fluids of different types is not
permitted!
Filling or mixing oils, lubricants or operating fluids (e.g. hydraulic oil,
gear oil, motor oil, coolant, etc.) of different types can lead to damage
to machine components caused by chemical reactions for example.
This can in turn result in severe damage to property and personal
injuries.
Only use oils, lubricants and operational fluids that are approved by
SENNEBOGEN.
Only mix oils, lubricants and operational fluids that are of the same type
or identical (same specifications) from one
manufacturer!
To Next Page
Loading...