sennebogen 830 E - Operation;Driving Operation

Safety - Safety instructions
1 - 34 07/2012Original operating instructions
1.9.7 Operation/driving operation
WARNING
 Persons working on or with the machine must be trained or
instructed for that purpose. Operation and work application may only
be carried out by trained personnel.
 The following applies for all work:
Only carry out work if the subgrade is firm and even and solid
enough.
 Proceed with the utmost caution if you bypass the stick end limitation
or other safety shutdowns.
 Ensure that there is no one in the danger area.
 Maintain safety clearance to overhead power lines.
 Only operate the machine from the driver's seat.
 When switching the attachment (e.g. grab), release the pressure
from the hydraulic system.
 Do not transport persons on the machine.
 Take environmental conditions into account, e.g. poor visibility, wind
speeds etc.
 Use the specific lifting capacity tables for the machine.
 Note performance specifications.
 Check that attachment points have a sufficient safe working load.
 Observe banksman signals if they are given.
 If visibility is poor, ensure that a banksman is used for giving the
required signs when reversing.
 Before moving onto ramps or inclines, make sure you obtain the
maximum permitted values from SENNEBOGEN.
 Position the boom in the travel direction during long journeys.
CAUTION
For crawler undercarriage:
Risk of severe damage to property!
Driving over raised or lowered obstacles such as thresholds, rails or
curbs can lead to high point loadings for the track frame, the idlers, the
chains, etc. This can cause cracking and breaking of the tracking
components (e.g. idlers).
Driving over such hindrances e.g. ties, rails, curbs, etc. is not permitted!
SENNEBOGEN accepts no liability for damages resulting from such
unintended usage!
Transit is only permitted on even, smooth and preferably concrete
(concrete slabs) paths/streets! Pay attention to ground load capacities.