Safety - Safety instructions
1 - 26 07/2012Original operating instructions
When cleaning swiveling connections a pressure washer must
not be used. This can cause large quantities of water, cleaning
agents and dirt particles that are placed under pressure, to
penetrate the sealing grooves and enter the swiveling connection.
These can no longer be removed by heavy greasing. This
significantly reduces the service life of the swiveling connection.
On no account must the exhaust gas treatment system be cleaned
with outside water or a high-pressure cleaner. Moisture can penetrate
cable connectors and sensors, and cause serious malfunctions. Water
must be prevented from entering the exhaust pipe.
WARNING
Electrical and electronic components such as the alternator, control
cabinet etc. as well as the bearings of the elevating cab (may cause
failure in the bearing surfaces and result in sudden, uncontrolled
motion when positioning the cab) must never be subjected to a direct
stream of water!
Wet cleaning of these components is prohibited!
When wet cleaning the machine, always make sure that no water/
moisture comes into contact with electrical or electronic components.
– Water infiltration can otherwise damage or destroy the machine
electronics. This can result in sudden, uncontrolled operating
movements.
To Next Page
Loading...