SENCON - Sennebogen Control System - Settings/Parameterization
SENCON / 01.2013
5 - 22
Note
If the operator presses the SCROLL button, he is in selection mode
and can switch between the functions.
A white frame indicates a selected field. Switch between the various
fields using the SCROLL wheel. If the SCROLL wheel is pressed again,
the selected field becomes active and the value can be changed by
turning the SCROLL wheel.
The selected field then has a green frame. To save the value,
the operator must press the SCROLL wheel again. The value
can be reset using the ESC button.
Information concerning the central lubrication system
The machine comes standard with a central lubrication system
for the rotary connection and the equipment.
The lubricating cycle can be adjusted in increments from -1 (75 min)
to +1 (45 min). The standard setting is 0 (60 min). The lubrication cycle
setting remains intact after restarting the engine.
CAUTION
Insufficient lubrication can damage the components.
Note
See the documentation Chapter 4.7 "Lubricating the machine
automatically" in the operating manual.
To Next Page
Loading...