SENCON - Sennebogen Control System - Settings/Parameterization
SENCON / 01.2013
5 - 37
Note
If the operator presses the SCROLL button, he is in selection mode and
can switch between the functions.
A white frame indicates a selected field. Switch between the various
fields using the SCROLL wheel. If the SCROLL wheel is pressed again,
the selected field becomes active and the value can be changed by
turning the SCROLL wheel.
The selected field then has a green frame. To save the value, the
operator must press the SCROLL wheel again. The value can be reset
using the ESC button.
Information on grapple rotational speed
The grapple rotational speed can be adjusted in increments from
0 (slow) to +4 (fast). The factory setting is +4 (fast). The grapple
rotational speed setting remains intact after restarting the engine.
To Next Page
Loading...