Tables
SIMOCODE pro
A-16 GWA 4NEB 631 6050-22 DS 03
11.7 Warning - Motor stop time > BU1 BU2
12.0 Warnings - Miscellaneous Warning - Ext. fault 1 BU1 BU2
12.1 Warning - Ext. fault 2 BU1 BU2
12.2 Warning - Ext. fault 3 BU1 BU2
12.3 Warning - Ext. fault 4 BU1 BU2
12.4 Warning - Ext. fault 5 BU2
12.5 Warning - Ext. fault 6 BU2
12.6 Reserved
12.7 Reserved
13.0 Warning - Analog module open circuit BU2
13.1 Warning - DM-F safety-oriented tripping
13.2 Warning - Test requirement DM-FL DM-FP
13.3 Reserved
13.4 Reserved
13.5 Reserved
13.6 Warning - DM-F feedback circuit DM-FL DM-FP
13.7 Warning - DM-FL DM-FL
14.0 Reserved
14.1 Status information - Protection Status - Emergency start executed IM UM
14.2 Status - Cooling down period active IM UM
14.3 Status - Pause time active IM UM
14.4 Reserved
14.5 Reserved
14.6 Status information - Receive Status - Cold starting (TPF) BU1 BU2
14.7 Reserved
15.0 Events -
Parameterization
Event - Start-up parameter block active BU1 BU2
15.1 Event - Parameter changes not allowed in the
current operating state
BU1 BU2
15.2 Event - Device does not support the required
functions
BU1 BU2
15.3 Event - Wrong parameter BU1 BU2
15.4 Event - Wrong password BU1 BU2
15.5 Event - Password protection active BU1 BU2
15.6 Event - Factory settings BU1 BU2
15.7 Event - Parameterization active BU1 BU2
17.0 Event - DM-FL - Configuration mode DM-FL
17.1 Event - DM FL - Configuration deviation DM-FL
17.2 Event - DM-FL waiting for start-up test DM-FL
17.3 Event - DM FP F PRM error DM-FP
17.4 Reserved
Byte.Bit Status information Information
Table A-5: Detailed messages of the slave diagnostics (Cont.)
To Next Page
Loading...
Need help?
General
