Siemens SIMOCODE pro System Manual

Data formats and data records
SIMOCODE pro
B-18 GWA 4NEB 631 6050-22 DS 03
*) The "DP Diagn." column contains the bits which are additionally available
in the diagnostics using PROFIBUS DP:
•F: Fault
• M: Status information
•W: Warning
• F9, F16:Error types
See also Chapter A.5 "Detailed messages of the slave diagnostics".
**) Event - PRM error number (bytes):
If parameterization is not possible, the number of the parameter group
(PRM group) which caused the error is transmitted here. You will find the
parameter groups in the parameter data records 130 to 133.
Fig. B-3: Example for parameter group
***) See "Error number" in Chapter B.6 "Data record 72 - Error buffer".
Byte.Bit Designation
(PRM group)
0.0 Reserved
4.0 Device configuration
(see above)(12)
Parameter group 12
. . .

Siemens SIMOCODE pro Specifications

General

Protection Class	IP20
Mounting Type	DIN rail mounting
Rated Operational Voltage	24 V DC
Rated Current	Up to 820 A
Protection Functions	Overload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range	-25°C to +60°C
Communication Protocols	PROFIBUS DP, PROFINET, Modbus RTU
Analog Outputs	Up to 2
Temperature Monitoring	PTC/KTY, RTD (PT100/PT1000)
Digital Outputs	Relay outputs, Solid-state outputs
Analog Inputs	0/4-20mA, PT100/PT1000