Siemens SIMOCODE pro System Manual

Data formats and data records
SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03
B-25
1) Value range dependent on current range of the IM/UM and the conversion factor
52.0 Word parameters (32)
52.0 Motor protection - Cooling
down period
Word 600 .. 65535 3000 IM/UM
54.0 Motor protection - Pause time Word 0 .. 65535 0 0 = Deactivated IM/UM
56.0 Execution time Word 0 .. 65535 10 0 = Deactivated
58.0 Monitoring the number of
starts - Time range for starts
Word 0 .. 65535 0 BU1
BU2
60.0 Monitoring the number of
starts - Interlocking time
Word 0 .. 65535 0 BU1
BU2
62.0 Stop time level > Word 0 .. 65535 0 BU1
BU2
64.0 Timer 1 - Limit Word 0 .. 65535 0 BU1
BU2
66.0 Timer 2 - Limit Word 0 .. 65535 0 BU1
BU2
68.0 Counter 1 - Limit Word 0 .. 65535 0 BU1
BU2
70.0 Counter 2 - Limit Word 0 .. 65535 0 BU1
BU2
72.0 Reserved Word 0
74.0 Reserved Word 0
76.0 D-word parameters (36)
76.0 Enabled commands Bit[32] 0 .. 1..1B 0..0B
80.0 Motor protection - Set current
I
s
1
D-word
1)
30 IM/UM
84.0 Motor operating hours level > D-word
0 .. 0xFFFFFFFF 0BU1
BU2
88.0 Reserved D-word 0
Byte
Bit
Designation
(PRM group)
Type Range De-
fault
Note Informa-
tion
Table B-12: Data record 130 - Basic device parameters 1 (Cont.)

Siemens SIMOCODE pro Specifications

General

Protection Class	IP20
Mounting Type	DIN rail mounting
Rated Operational Voltage	24 V DC
Rated Current	Up to 820 A
Protection Functions	Overload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range	-25°C to +60°C
Communication Protocols	PROFIBUS DP, PROFINET, Modbus RTU
Analog Outputs	Up to 2
Temperature Monitoring	PTC/KTY, RTD (PT100/PT1000)
Digital Outputs	Relay outputs, Solid-state outputs
Analog Inputs	0/4-20mA, PT100/PT1000