Siemens SIMOCODE pro System Manual

Data formats and data records
SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03
B-31
7.6 Reserved Bit 0
7.7 Reserved Bit 0
8.0 Calculation module 2 - Operating
mode
Bit 0, 1 0 0 = Word
1= D-word
BU2
8.1 Reserved Bit 0
8.2 DM-F - Safe tripping function Bit 0, 1 0 0 = No
1 = Yes
DM-F
8.3 DM-F - Safety-oriented tripping
reset
Bit 0, 1 0 0 = Manual,
1 = Auto
DM-F
8.4 Timestamping active Bit 0, 1 0 BU2
8.5 Reserved Bit 0
8.6 Reserved Bit 0
8.7 Reserved Bit 0
9.0 DM-FL - Configuration 1 Bit 0, 1 0 Configurable
parameters
comparable
with the
module
configuration
DM-FL
9.1 DM-FL - Configuration 2 Bit 0, 1 0 DM-FL
9.2 DM-FL - Configuration 3 Bit 0, 1 0 DM-FL
9.3 DM-FL - Configuration 4 Bit 0, 1 0 DM-FL
9.4 DM-FL - Configuration 5 Bit 0, 1 0 DM-FL
9.5 DM-FL - Configuration 6 Bit 0, 1 0 DM-FL
9.6 DM-FL - Configuration 7 Bit 0, 1 0 DM-FL
9.7 DM-FL - Configuration 8 Bit 0, 1 0 DM-FL
10.0 Bit[2] - Parameters (21)
10.0 3UF50 basic type Bit[2] 0, 1, 2 0 BU2
10.2 Reserved Bit[2] 0
10.4 Reserved Bit[2] 0
10.6 UVO operating mode Bit[2] 0, 1, 2 0 0 =
Deactivated,
1 = Activated
BU2
11.0 Trip monitoring U< Bit[2] 0, 1, 2 1 0 = ON
(always)
1 = ON+
(always, not
TPF)
2 = RUN
(motor ON, not
TPF)
UM
11.2 Warning monitoring U< Bit[2] 0, 1, 2 1 UM
11.4 Reserved Bit[2] 0
11.6 Reserved Bit[2] 0
Byte.
Bit
Designation
(PRM group)
Type Range Unit De-
fault
Note Informa-
tion
Table B-14: Data record 132 - Extended device parameters 1 (Cont.)

Siemens SIMOCODE pro Specifications

General

Protection Class	IP20
Mounting Type	DIN rail mounting
Rated Operational Voltage	24 V DC
Rated Current	Up to 820 A
Protection Functions	Overload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range	-25°C to +60°C
Communication Protocols	PROFIBUS DP, PROFINET, Modbus RTU
Analog Outputs	Up to 2
Temperature Monitoring	PTC/KTY, RTD (PT100/PT1000)
Digital Outputs	Relay outputs, Solid-state outputs
Analog Inputs	0/4-20mA, PT100/PT1000