Siemens SIMOCODE pro System Manual

System description
SIMOCODE pro
1-56 GWA 4NEB 631 6050-22 DS 03
[mA] In 1/Output (example) Displays the current value at input 1 of the analog module and at the
output of the analog module in mA.
Note
Only possible if the analog module is used.
[mA] In 2/Output (example) Displays the current value at input 2 of the analog module and at the
output of the analog module in mA.
Note
Only possible if the analog module is used.
[mA] Inputs (example) Displays the current value at both inputs of the analog module
in mA.
Note
Only possible if the analog module is used.
Max. temp. °C (example) Displays the maximum temperature of all used sensor measuring
circuits of the temperature module in °C.
Note
Only possible if a temperature module is used.
Temperatures °C (example) Displays the individual temperatures of all used sensor measuring
circuits of the temperature module in °C.
Note
Only possible if a temperature module is used.
Table 1-10: Read and adapt main display (Cont.)

Siemens SIMOCODE pro Specifications

General

Protection Class	IP20
Mounting Type	DIN rail mounting
Rated Operational Voltage	24 V DC
Rated Current	Up to 820 A
Protection Functions	Overload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range	-25°C to +60°C
Communication Protocols	PROFIBUS DP, PROFINET, Modbus RTU
Analog Outputs	Up to 2
Temperature Monitoring	PTC/KTY, RTD (PT100/PT1000)
Digital Outputs	Relay outputs, Solid-state outputs
Analog Inputs	0/4-20mA, PT100/PT1000