Siemens SIMOCODE pro System Manual

System description
SIMOCODE pro
1-64 GWA 4NEB 631 6050-22 DS 03
Interlocking time active
Change-over pause active
OPO, Remote, TPF
FC, FO, TC, TO Only for "Positioner" control functions, can vary according to the
actual positioner function.
Positioner closes
Positioner opens
Only for "Positioner" control functions.
Non-maintained command mode
Table 1-12: Motor protection and motor control status (Cont.)

Siemens SIMOCODE pro Specifications

General

Protection Class	IP20
Mounting Type	DIN rail mounting
Rated Operational Voltage	24 V DC
Rated Current	Up to 820 A
Protection Functions	Overload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range	-25°C to +60°C
Communication Protocols	PROFIBUS DP, PROFINET, Modbus RTU
Analog Outputs	Up to 2
Temperature Monitoring	PTC/KTY, RTD (PT100/PT1000)
Digital Outputs	Relay outputs, Solid-state outputs
Analog Inputs	0/4-20mA, PT100/PT1000