Siemens SIMOCODE pro System Manual

System description
SIMOCODE pro
1-74 GWA 4NEB 631 6050-22 DS 03
Compatibility mode 1
3UF50 mode
3UF50 mode
DPVO, DPV1
3UF50 basic type
Diagnostic device fault/status info Displays which type of diagnostic information "device fault" or
"status information" is sent by SIMOCODE pro to a higher-level
automation system via PROFIBUS.
Diagnostic warning
Diagnostic fault
Displays which type of diagnostic information "warning" or "fault" is
sent by SIMOCODE pro to a higher-level automation system via
PROFIBUS.
Table 1-14: Status display for PROFIBUS communication (Cont.)

Siemens SIMOCODE pro Specifications

General

Protection Class	IP20
Mounting Type	DIN rail mounting
Rated Operational Voltage	24 V DC
Rated Current	Up to 820 A
Protection Functions	Overload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range	-25°C to +60°C
Communication Protocols	PROFIBUS DP, PROFINET, Modbus RTU
Analog Outputs	Up to 2
Temperature Monitoring	PTC/KTY, RTD (PT100/PT1000)
Digital Outputs	Relay outputs, Solid-state outputs
Analog Inputs	0/4-20mA, PT100/PT1000