Siemens SINAMICS S120 Combi - Connection of DC link busbars and 24 V busbars

Electrically connecting Motor Modules and DC link components
8.3 Connection of DC link busbars and 24 V busbars
SINAMICS S120 Combi
Manual, 11/2017, 6SL3097-4AV00-0BP7
183
Remove the DC-link cover.
Remove the DC-link side cover.
8.3
Connection of DC link busbars and 24 V busbars
The following steps are necessary to connect a component to the DC link and the 24 V
busbars of the S120 Combi:
1. Use a suitable screwdriver or tool from the accessories pack to open the protective cover
of the component which is to be connected.
2. Remove the DC-link side cover at the connection location.
Figure 8-1 S120 Combi and Motor Module without DC-link covers