Siemens SINAMICS S120 Combi - Approved Controls

S120 Combi Power Modules
4.1 Introduction
SINAMICS S120 Combi
62 Manual, 11/2017, 6SL3097-4AV00-0BP7
4.1.3
Approved controls
The S120 Combi is approved for operation with the following controls:
● SINUMERIK 828D with PPU versions
– PPU 24..2
– PPU 26..2
– PPU 28..2
– PPU 24..3
– PPU 26..3
– PPU 28..3
– PPU 290.3
Table 4- 2 Overview of the article numbers of the approved SINUMERIK 828D controls
PPU version
Keyboard
Article number (without CNC software)
240.2 Vertical 6FC5370-4AT20-0AA0 (Turning)
6FC5370-4AM20-0AA0 (Milling)
241.2 Horizontal 6FC5370-3AT20-0AA0 (Turning)
6FC5370-3AM20-0AA0 (Milling)
260.2
Vertical
6FC5370-6AA20-0AA0
261.2
Horizontal
6FC5370-5AA20-0AA0
280.2
Vertical
6FC5370-8AA20-0AA0
281.2
Horizontal
6FC5370-7AA20-0AA0
240.3
Vertical
6FC5370-4AA30-0AA0
241.3
Horizontal
6FC5370-3AA30-0AA0
260.3
Vertical
6FC5370-6AA30-0AA0
261.3
Horizontal
6FC5370-5AA30-0AA0
280.3
Vertical
6FC5370-8AA30-0AA0
281.3
Horizontal
6FC5370-7AA30-0AA0
290.3
Vertical
6FC5370-8AA30-0BA0
● SINUMERIK 840D sl with NCU versions
– NCU 710.3 PN
Table 4- 3 Overview of the article numbers of the approved SINUMERIK 840D controls
NCU version
Article number (without CNC software)
710.3
6FC5371-0AA30-0AA1