Electrically connecting Motor Modules and DC link components
8.4 Connecting an additional component
SINAMICS S120 Combi
186 Manual, 11/2017, 6SL3097-4AV00-0BP7
Connecting an additional component
An additional component is connected as follows to the DC-link busbars and the 24 V
busbars:
1. Use a suitable screwdriver or tool from the accessories pack to open the protective cover
of the component which is to be connected.
2. Remove the DC-link side covers of both components at the connection location
Figure 8-3 Prepared Motor Modules to connect the DC-link busbars
To Next Page
Loading...
