Siemens SINAMICS SIMOTICS S200 PROFINET User Manual

Cause: Data backup is incomplete
The partially sa
ved parameters are not loaded the next time the system runs up.
For the system to successfully power up, all of the parameters must have been completely backed up.
Alarm value (r2124, interpret decimal):
Only for internal Siemens troubleshooting.
Remedy: Save all parameters.
See also: p0977 (Save all par
ameters)
F01033 Units changeover: Reference parameter value invalid
Message class: Error in the parameterization / con󹪝guration / commissioning pr
ocedure (18)
Message value: Parameter: %1
Component: None
Response: NONE
Acknowledgment: IMMEDIATELY
Cause: When changing over the units to the referred representation type, it is not permissible for any of the required reference
par
amet
ers to be equal to 0.0
Fault value (r0949, parameter):
Reference parameter whose value is 0.0.
Remedy: Set the value of the reference parameter to a number di󹪜erent than 0.0.
See also: p0304, p0305, p2000, p2002, p2003
F01034 Units changeover: Calculation parameter values after reference value change unsuccessful
Message class: Error in the parameterization / con󹪝guration / commissioning pr
ocedure (18)
Message value: Parameter: %1
Component: None
Response: NONE
Acknowledgment: IMMEDIATELY
Cause: The change of a reference parameter meant that for an involved parameter the selected value was not able to be re-
calculat
ed in the per unit r
epresentation. The change was rejected and the original parameter value restored.
Fault value (r0949, parameter):
Parameter whose value was not able to be re-calculated.
See also: p0304, p0305, p2000, p2002, p2003
Remedy: - Select the value of the reference parameter such that the parameter involved can be calculated in the per unit
represent
ation.
A01035 ACX: Parameter backup 󹪝le corrupted
Mes
sage class: Hardware/software error (1)
Message value: %1
Component: Control Unit (CU)
Response: NONE
Acknowledgment: NONE
System messages
12.3Faults and alarms
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
442 Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB

Siemens SINAMICS SIMOTICS S200 PROFINET Specifications

General

Brand	Siemens
Model	SINAMICS SIMOTICS S200 PROFINET
Category	Servo Drives
Language	English