Siemens SINAMICS SIMOTICS S200 PROFINET - Page 541

Message value: -
Component: Control Unit (CU)
Response: NONE
Acknowledgment: NONE
Cause: - For the converter, the options that require a license are being used but the licenses are not su󹪟cient.
- An er
ror occur
red when checking the existing licenses.
Alarm value (r2124, interpret decimal):
0: The existing license is not su󹪟cient.
1: An adequate license was not able to be determined as the memory card with the required licensing data was withdrawn
in operation or the memory card has developed a defect.
2: An adequate license was not able to be determined as there is no licensing data available on the memory card.
3: An adequate license was not able to be determined as there is no licensing data available on the memory card.
4, 5, 6, 7: An adequate license was not able to be determined as the licensing data were manipulated and are therefore
invalid.
8,9: An internal error occurred when checking the license.
Remedy: For alarm value = 0:
Additional licenses are r
equired and must be activated.
For alarm value = 1:
Reinsert or replace the memory card that matches the system.
For alarm value = 2:
Transfer the license 󹪝le to the converter.
For alarm value = 3:
Compare the license 󹪝le name (after "LK_" to ".ZIP") with the serial number of the memory card.
Transfer the appropriate license 󹪝le to the converter.
For alarm value = 4, 5, 6, 7, 8, 9:
- Carry out a POWER ON.
- Upgrade 󹪝rmware to later version.
- Contact Technical Support.
Note:
An overview of the converter functions requiring a license can be displayed using a commissioning tool in the online mode.
Depending on the commissioning tool, you can also obtain the necessary licensing (serial number, license 󹪝le, Trial License
Mode).
A13030 Trial License activated
Message class: Error in the parameterization / con󹪝guration / commissioning pr
ocedure (18)
Message value: -
Component: Control Unit (CU)
Response: NONE
Acknowledgment: NONE
Cause: The "Trial License" function was activated. One of the available periods is expiring.
Remedy: Not necessary.
The alarm is aut
omatically wit
hdrawn after the periods have expired.
A13031 Trial License period expired
Message class: Error in the parameterization / con󹪝gur
ation / commissioning pr
ocedure (18)
Message value: -
Component: Control Unit (CU)
Response: NONE
Acknowledgment: NONE
Cause: One of the available periods of the "Trial License" function has expired.
System messages
12.3Faults and alarms
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB 539