Siemens SINAMICS SIMOTICS S200 PROFINET - Page 637

14.2.11 Axial and radial forces
14.2.11.1 Permis
sible axial forces
Technical data
Table 14-25 Permissible axial forces
Type Axial force, static
1)
F
A s
tat
/ N
1FL2102 50
1FL2☐03 98
1FL2104
1FL2204
100
1FL2☐05 120
1FL2304 140
1FL2306 245
1FL2310 590
1)
The speci󹪝ed axial f
orces are determined by the spring loading and therefore also apply to motors with
holding brake.
Note
Applications with
an angular toothed pinion directly on the motor shaft are not permitted if the
permissible axial forces are exceeded.
Technical data
14.2Technical data of the motor
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB 635