Siemens SINAMICS SIMOTICS S200 PROFINET - Page 693

A.3 Parameters
A.3.1 Explanation of t
he list of parameters
Overview
The representation of a parameter includes as a maximum the information listed below.
Depending on the speci󹪝c parameter, some of the listed information is not applicable.
The parameters are displayed according to the following example:
8QLW
)DFWRU\VHWWLQJ0D[0LQ
1DPHRIWKHJURXSV3DUDPHWHUJURXS
5HDG\IRURSHUDWLRQ&DQEHFKDQJHGLQWKHRSHUDWLQJVWDWH
5HDGSHUPLVVLRQ
:ULWHSHUPLVVLRQ
9LVLEOHLQ6WDQGDUGGLVSOD\'DWDW\SH,QWHJHU
3DUDPHWHUQDPH
6DIHW\UHODWHGQRWHFRUUHVSRQGLQJWRWKHZDUQLQJQRWHFRQFHSW'DQJHU&DXWLRQ
:DUQLQJ1RWLFH
6HHDOVR
6HHDOVR
'HSHQGHQF\
>@ 1DPHDQGPHDQLQJRILQGH[
>@ 1DPHDQGPHDQLQJRILQGH[,QGH[
%LWDUUD\%LW6LJQDOQDPHVLJQDOVLJQDO
7H[W
7H[W
1RWH
7H[W
5HFRPPHQGDWLRQ
1DPHRIYDOXH
1DPHRIYDOXH
<HV1R
1R<HV1DPHRIELW
1DPHRIELW
9DOXH
9DULDQW
7H[W
'HVFULSWLRQ
5HDGGULYHGDWDRUDFNQRZOHGJHPHVVDJHV
(GLWGHYLFHFRQILJXUDWLRQRUGULYHDSSOLFDWLRQV



S[[[U[[[
)[[[[[$[[[[[&[[[[[


U[[[[
Note
Some parame
ters may have di󹪜erent properties and descriptions depending on the selected axis
type. And those parameters are displayed twice in the parameter list with additional labels. You
need to refer to the speci󹪝c parameters according to your actual axis type.
Description of function
Paramet
er number
The parameter number is made up of a "p", "r" or "c", followed by several numbers and
optionally an index and bit array.
Appendix
A.3Parameters
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB 691