Siemens SINAMICS SIMOTICS S200 PROFINET - Page 802

p2586 EPOS jog 2 setpoint velocity
 Data type: FloatingPoint32 Visible in: S
tandard display 
Read permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or driv
e applications
Can be changed in the operating
stat
e:
Operation
Parameter group: Jog
 Unit: mm/s
 Min:
-4e+07 [mm/s]
Max:
4e+07 [mm/s]
Factory setting:
5.000 [mm/s]
Description: Sets the setpoint velocity for jog 2.
Dependency: See also: p2588, c2590, c2591
p2586 EPOS jog 2 setpoint velocity
S200 Basic PN (EPOS
Lastseite r
otierend),
S200 PN (EPOS
Lastseite rotierend)
Data type: FloatingPoint32 Visible in: Standard display 
Read permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or driv
e applications
Can be changed in the operating
stat
e:
Operation
Parameter group: Jog
 Unit: °/s
 Min:
-4e+07 [°/s]
Max:
4e+07 [°/s]
Factory setting:
180.000 [°/s]
Description: Sets the setpoint velocity for jog 2.
Dependency: See also: p2588, c2590, c2591
p2587 EPOS jog 1 traversing distance
 Data type: FloatingPoint32 Visible in: S
tandard display 
Read permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or driv
e applications
Can be changed in the operating
stat
e:
Operation
Parameter group: Jog
 Unit: mm
 Min:
0.0000 [mm]
Max:
2.1474828e+09 [mm]
Factory setting:
1.0000 [mm]
Description: Sets the traversing distance for incremental jog 1.
Dependency: See also: p2585, c2589, c2591
Note
Incremental jog 1 is s
tarted with c2591 = 1 signal and c2589 = 0/1 signal.
With c2589 = 0 signal, incremental jogging is interrupted.
Appendix
A.3Parameters
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
800 Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB