Siemens SINAMICS SIMOTICS S200 PROFINET - Page 804

c2589 EPOS jog 1
 Data type: Unsigned8 Visible in: S
tandard display 
Read permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or driv
e applications
Parameter group: Jog
Unit: -
Description: Signal for jog 1.
Dependency: When jogging, the axis is accelerated or braked with the maximum acceleration/deceleration (p2572/p2573).
c2591 = 0 signal
The axis endles
sly mo
ves with the setpoint velocity, jog 1 (p2585).
c2591 = 1 signal
The axis traverses through a parameterized distance (p2585) with the setpoint velocity, jog 1 (p2587).
See also: p2572, p2573, p2585, p2587, c2591
NOTICE
The parameter may be protected as a result of r0922 and cannot be changed.
c2590 EPOS jog 2
 Data type: Unsigned8 Visible in: S
tandard display 
Read permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or driv
e applications
Parameter group: Jog
Unit: -
Description: Signal for jog 2.
Dependency: When jogging, the axis is accelerated or braked with the maximum acceleration/deceleration (p2572/p2573).
c2591 = 0 signal
The axis endlessly mo
ves with the setpoint velocity, jog 2 (p2586).
c2591 = 1 signal
The axis traverses through a parameterized distance (p2586) with the setpoint velocity, jog 2 (p2588).
See also: p2572, p2573, p2586, p2588, c2591
NOTICE
The parameter may be protected as a result of r0922 and cannot be changed.
c2591 EPOS jogging incremental
 Data type: Unsigned8 Visible in: S
tandard display 
Read permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or driv
e applications
Parameter group: Jog
Unit: -
Description: Signal for incremental jogging.
Dependency: See also: p2585, p2586, p2587, p2588, c2589, c2590
c2595 EPOS homing start
 Data type: Unsigned8 Visible in: S
tandard display 
Read permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or driv
e applications
Parameter group: Homing
Unit: -
Appendix
A.3Parameters
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
802 Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB