Siemens SINAMICS SIMOTICS S200 PROFINET - Page 830

r2673 EPOS actual acceleration override
 Data type: FloatingPoint32 Visible in: S
tandard display 
Read permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or driv
e applications
Parameter group: Jog, Traversing blocks, Direct setpoint input (MDI)
Unit: %
Description: Displays the acceleration override presently being processed.
Note
An over
ride of 100% is e󹪜ective in the "Jogging" and "Active homing" operating modes.
r2674 EPOS actual deceleration override
 Data type: FloatingPoint32 Visible in: S
tandard display 
Read permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or driv
e applications
Parameter group: Jog, Traversing blocks, Direct setpoint input (MDI)
Unit: %
Description: Displays the deceleration override presently being processed.
Note
An override of 100% is e󹪜ective in the "Jogging" and "Active homing" operating modes.
r2675 EPOS actual task
 Data type: Integer16 V
isible in: Standard display 
Read permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or driv
e applications
Parameter group: Traversing blocks
Unit: -
Description: Display for the task presently being processed.
Value: 0: Inactive
 1: POSITIONING
 2: FIXED STOP
 3: ENDLESS_POS
 4: ENDLESS_NEG
 5: WAITING
 6: GOTO
 7: SET_O
 8: RESET_O
 9: JERK
Dependency: See also: p2621
r2676 EPOS actual task parameter
 Data type: Int
eger32 V
isible in: Standard display 
Read permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or driv
e applications
Parameter group: Traversing blocks
Unit: -
Description: Displays the task parameter presently being processed in the "traversing blocks" operating mode.
Dependency: See also: p2622
Appendix
A.3Parameters
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
828 Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB