Siemens SINAMICS SIMOTICS S200 PROFINET - Page 856

Note
The paramet
er in󹪞uences the access from applications.
1 signal:
Ethernet interface X127 is enabled for access.
0 signal:
Ethernet interface X127 is blocked and cannot be accessed.
The signal is not in󹪞uenced by restoring the factory settings.
c8997[0...2] PROFINET X150 enable
 Data type: Unsigned8 Visible in: Ext
ended display 
Read permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or driv
e applications
Parameter group: Con󹪝guration
Unit: -
Description: Signal to enable PROFINET interface X150 for applications.
Index: [0] = Secure S7 Protocol Startdrive
[1] = Web serv
er HTTPS
[2] = S7 protocol PCS7
Note
The paramet
er in󹪞uences the access from applications.
1 signal:
PROFINET interface X150 is enabled for access.
0 signal:
PROFINET interface X150 is inhibited for access.
The signal is not in󹪞uenced by restoring the factory settings.
p9603.0 SI control
S200 PN Data type: Unsigned32 Visible in: S
tandard display 
Read permission: Read drive data or acknowledge messages
Write permission: Edit Safety Integrated application
Can be changed in the operating
s
tat
e:
Commissioning (Safety Integrated)
Parameter group: Safety Integrated
 Unit: -
 Min:
-
Max:
-
Factory setting:
0001 bin
Description: Sets the type of control for the safety functions integrated in the drive.
Bit array: Bit Signal name 1 signal 0 signal 
 00 Control via F-DI Enable Inhibit 
Note
When online safety commis
sioning has been completed, a change results in an automatic restart.
p9604.0 SI enable
S200 PN Data type: Unsigned32 Visible in: S
tandard display 
Read permission: Read drive data or acknowledge messages
Write permission: Edit Safety Integrated application
Can be changed in the operating
s
tate:
Commissioning (Safety Integrated)
Parameter group: Safety Integrated
 Unit: -
Appendix
A.3Parameters
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
854 Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB