Siemens SINAMICS SIMOTICS S200 PROFINET - Page 886

A.4.1.3 Assembling the I/O connector
Requirement
You have prepared appropriate tools, raw cables, and the Siemens 20-pin MDR connector.
Procedure





5HPRYHWKHRXWHUVKHDWKRIWKHFDEOH
)ROGWKHFDEOHVKLHOGEDFNZDUGRYHUWKHFDEOHVKHDWK
DQGUHPRYHWKHLQVXODWLRQIURPWKHZLUHVE\PP
6OLGHWKHKHDWVKULQNDEOHWXEHVRQWRWKHZLUHV6ROGHUWKHZLUHVWRWKHFRQQHFWRU
:HOGLQJJXQ
&RYHUWKHSLQVZLWKKHDWVKULQNDEOHWXEHVDQG
ZUDSWKHIROGHGFDEOHVKLHOGZLWKDOXPLQXP
IRLOWDSH
$OXPLQXPIRLO
*URXQGSODWH
7LJKWHQLQJWRUTXH
1P
,QVWDOOWKHJURXQGSODWH
,QVWDOOWKHKRXVLQJ
7LJKWHQLQJWRUTXH
1P
PP
PP
PP
FigureA-2 Assembling the I/O cable
Appendix
A.4Assembling cables
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
884 Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB