Siemens SIPROTEC 7UM62 User Manual

Index
SIPROTEC, 7UM62, Manual
C53000-G1176-C149-7, Release date 03.2010
636
R
Rack mounting 388
Rate-of-frequency-change protection 193
Rear Interfaces 26
Reassembly of Device 386
Reference Voltages 282
Regulations 461
Replacing Interfaces 366, 383
Resetting stored LEDs / relays 39
Resistor Unit 533
Restart 39
Restart inhibit for motors 255
Restart limit 256
Restraint Currents (stabilized) 423
Reverse Power Protection 29, 483
Reverse power protection 145
rms values 344
Rotor Earth Fault Protection
(R, fn) 31
Rotor earth fault protection 213
Rotor Ground Fault Protection 502
Rotor Ground Fault Protection at Standstill 407
Rotor Ground Fault Protection: Measuring Circuit
Monitoring 429
Rotor overtemperature 255
RTD 316
RTD-boxes for Temperature Detection 510
S
Sampling frequency adaptation 416
Secondary Check 393
Sensitive Earth Current Protection 30
Sensitive earth current protection 211
Sensitive Earth Current Protection B 31
Sensitive Ground Current Protection 497
Sensitive Ground Current Protection IEE-B 500
Sensitive Rotor Earth Fault Protection
with 1 to 3 Hz Square Wave Voltage 31
Sensitive Rotor Ground Fault Protection with 1 to 3 Hz
504
Serial Interfaces 24
Series Device 531
Service / Modem Interface 457
Service Conditions 464
Service Interface 26
Setting groups 62
Shaft current protection 234
Software Monitoring 284
Spill Current 437
Spontaneous Display Messages 327
Spontaneous Fault Display 39
Spontaneous Messages 330
Standard interlocking 353
Startup Overcurrent Protection 28, 98, 475
Statistics 331, 331, 521
Stator earth fault protection 213
Stator earth fault protection (100 %) with 20 Hz bias
voltage 31
Stator earth fault protection (100 %) with 3rd harmonic 30
Stator earth fault protection (90 %) 30, 203
Stator earth fault protection with 3rd harmonic 215
Stator Ground Fault Protection (100 %) with 20 Hz Inject-
ed Voltage 499
Stator Ground Fault Protection (100 %) with 3rd
Harmonic 498
Stator Ground Fault Protection (90 %) 496
Stator Overload Protection 471
Stator overload protection 81
Switchgear Control 349
Switching authority 356
Switching Elements on the Printed Circuit Boards 370
Switching mode 357
System Interface 26, 457
T
Temperature detection using RTD boxes 316
Temperature Measurement via Thermoboxes 32
Temperatures 463
Terminating Resistors 366
Termination 384, 391
Test mode 401
Test Switch 396
Test: System interface 401
Testing Analog Output 406
Thermal measured values 342
Thermal overload protection 81
Thermal Overload Protection 49 28
Threshold monitoring 302
Threshold Value Monitoring 32
Time Allocation 520
Time constant 86
Time Synchronization 522
Time Synchronization Interface 460
Time synchronization interface 392
Transformation Ratio INs 54
Transformation Ratio UN 55
Transmission block 401
Trip Circuit Monitoring 364, 521
Trip circuit supervision 295
Trip Counter 331
Trip Time Characteristics: ANSI 468
Trip Time Characteristics: IEC 466
Trip/Close Tests for the Configured Operating
Devices 414, 414
Tripping Logic 328
Tripping Test with Circuit Breaker 414

Siemens SIPROTEC 7UM62 Specifications

General

Brand	Siemens
Model	SIPROTEC 7UM62
Category	Protection Device
Language	English