Ski-Doo TOURING E LT 1997 - Battery; Removal; Cleaning

Section 05 ELECTRICAL
Sub-Section 05 (BATTERY)
05-05-1
BATTERY 5
REMOVAL
All Models
WARNING : Battery BLACK negative ca-
ble must always be disconnected first and
connected last.
WARNING : Never charge or boost bat-
tery while installed on vehicle.
Remove belt guard.
Unfasten spark plug cables from fan housing. Un-
plug spark plug caps.
Remove throttle cable attachment from air silenc-
er.
Unplug CDI box harness connector.
Slacken collar on carburetor adaptors. Remove air
silencer. CDI box will come along with.
1. Attachment
2. CDI box harness connector
Unfasten retaining strips.
Open strips and lift battery protective boot.
Remove vent tube.
Step : Unfasten and open
Step : Lift protective boot
Step : Remove vent tube
All Models
Withdraw battery from vehicle being careful not
lean it so that electrolyte flows out of vent tube.
CAUTION : Should any electrolyte spill-
age occur, immediately wash off with a
solution of baking soda and water to prevent
damage to vehicle components.
CLEANING
Clean the battery, battery casing, vent tube, caps,
cables and battery posts using a solution of baking
soda and water.
CAUTION : Do not allow cleaning solution
to enter battery interior since it will de-
stroy the electrolyte.
1. Baking soda
;
;
A03C18A
1
2
A06E1BA
1
2
3
1
2
3
-
-
A17E0LA
1