Section 07 STEERING/FRONT SUSPENSION
Sub-Section 02 (STEERING SYSTEM)
07-02-4
21, Hardened Washer
Install a hardened washer on each side of the arm.
TYPICAL
1. Hardened washers
17, Steering Arm
The steering arm angles should be equal on both
sides when skis are parallel with vehicle.
Steering arm must run parallel to ski.
TYPICAL
1. Parallel
Tighten the steering arm pinch bolt to the torque
specified in the exploded view.
9,13,15, Ball Joint Nut and Jam Nut
Tighten ball joint, nuts and jam nuts to specified
torque (see exploded view).
11,12, Steering Arm Nut and Bolt
Tighten steering arm nuts to specified torque (see
exploded view).
ADJUSTABLE HANDLEBAR
1,3, Steering Column and Handlebar
If applicable, remove the steering clamp and nuts
holding the handlebar to the steering column.
2,4,5,6, Handlebar Support, Steering
Clamp, Bolt and Nut
Install the handlebar support, steering clamp, the
4 screws and nuts to the column, as illustrated.
See applicable exploded view.
Adjust the steering handlebar to the desired posi-
tion.
Lock the handlebar in place by tightening the 4
nuts as specified in the illustrations.
TYPICAL
1. Torque to 26 N•m (19 lbf•ft)
A. Equal gap all around
A25G0MA
1
A06G02A
1
-
CAUTION
Tighten the nuts equally in a criss-cross se-
quence and ensure there is an equal gap on
each side of the clamps.
◆
WARNING
Avoid contact between the brake handle and
the windshield by NOT adjusting the handle-
bar too high.
A06G19A
1
A
To Next Page
Loading...
