Section 04 TRANSMISSION
Sub-Section 08 (GEARBOX)
04-08-2
REMOVAL
1,2, Cable and Cable Housing
Remove screw from underneath top portion of
transmission. Remove cable barrel from shifter:
see last photo.
1. Remove this screw
Pull out cable from underneath top portion of
transmission.
1. Cable
ADJUSTMENT
6, Tie Rod
Loosen tie rod lock nut. Remove clip.
Unfasten tie rod end.
1. Clip
2. Lock nut
Adjust tie rod length in a way that gear shift lever
does not contact console. Check 2
nd
gear posi-
tion. Retighten ball joint lock nuts.
1, Cable
With gear shift lever in neutral position, there
should be no cable free play.
Adjust reverse lock out cable by cable housing ad-
juster
no. 2
. If more adjustment is needed, slack-
en or tighten cable barrel accordingly.
1. Cable barrel
2. No free play
A22D0SA
1
A22D0ZA
1
A22D0QA
1
2
1
2
A22D01A
1
2
To Next Page
Loading...
