Section 01 LUBRICATION AND MAINTENANCE
Sub-Section 01 (LUBRICATION AND MAINTENANCE CHART)
01-01-2
* Before installing new spark plugs at pre-season preparation, it is suggested to burn excess storage oil by starting
the engine with the old spark plugs. Only perform this operation in a well ventilated area.
➀ 10-HOUR OR 500 km (300 mi) INSPECTION (To be performed by dealer)
➁ WEEKLY OR EVERY 240 km (150 mi)
➂ MONTHLY OR EVERY 800 km (500 mi)
➃ ONCE A YEAR OR EVERY 3200 km (2000 mi)
➄ STORAGE (To be performed by dealer)
➅ PRE-SEASON PREPARATION (To be performed by dealer)
1. Change oil at 10-hour inspection for Skandic WT/SWT/WT LC
2. Apply anti-seize lubricant (P/N 413 7010 00) on ACM rod every 10 hours or 500 km (300 mi).
Suspension Adjustments AS REQUIRED
Section 06: See appropriate
sub-section and
Operator’s Guide
Suspension Lubrication
✔2 ✔
Section 06: See appropriate
sub-section
Suspension Condition
✔✔
Section 06: See appropriate
sub-section
Suspension Stopper Strap Condition
✔
Section 06: See appropriate
sub-section
Track Condition
✔✔
Sub-section 06-05
Track Tension and Alignment
✔
AS REQUIRED Sub-section 06-05
Spark Plugs*
✔
Sub-section 05-04
Engine Timing
✔✔
Sub-section 05-03
Battery Condition
✔✔✔
Sub-section 05-05
Headlight Beam Aiming
✔
Sub-section 08-02
Wiring Harnesses, Cables and Lines
✔✔
Sub-section 08-02
Operation of Lighting System
(HI/LO Beam, Brake Light, etc.)
Test Operation of Emergency Cut-Out Switch
and Tether Cut-Out Switch
✔✔ ✔
Operator’s Guide
Rags in Air Intake and Exhaust System
✔✔
This section no. 6
Engine Compartment
✔✔
This section no. 7
General Inspection
✔✔✔
This section no. 8
➀➁➂➃➄➅
REFER TO
To Next Page
Loading...
