Section 05 ELECTRICAL
Sub-Section 05 (BATTERY)
05-05-9
Apply silicone dielectric grease (P/N 413 7017 00)
on battery posts and connectors.
S-Series
BATTERY CONNECTION — S-SERIES
1. Vent tube on fitting
Skandic WT/SWT/WT LC
See photos in removal procedures for proper bat-
tery installation.
AIR SILENCER INSTALLATION — SKANDIC WT
1. Locking tie
All Models
Ensure that vent tube is not kinked or blocked
then install protective boot over battery.
Close and fasten retaining strips.
Reinstall air silencer.
Fasten spark plug cables to fan housing.
Reinstall throttle cable to air silencer. See removal
illustration.
-
CAUTION
Negative battery terminal should always be
disconnected FIRST and reconnected LAST.
A03H1SA
1
A22C0BA
1
To Next Page
Loading...
