Section 03 ENGINE
Sub-Section 05 (OIL INJECTION SYSTEM)
03-05-3
1. Adjuster nut
2. Marks in line
To Bleed Oil Lines
Bleed main oil line (between tank and pump) by
loosening the bleeder screw until air has escaped
from the line. Add injection oil as required.
1. Small oil lines
2. Bleeder screw
3. Main oil line
Reinstall all parts.
Bleed the small oil line between pump and intake
manifold by running engine at idle while holding
the pump lever in fully open position.
NOTE:
Make a J hook out of mechanical wire to
lift the lever.
TYPICAL — ENGINE AT IDLE
-
CAUTION
Proper oil injection pump adjustment is very
important. Any delay in the opening of the
pump can result in serious engine damage.
2
A06C3JA
1
2
A06C3JA
1
2
A06C3JB
1
3
A06C3KA
To Next Page
Loading...
