Section 06 REAR SUSPENSION
Sub-Section 03 (DRIVE AXLE)
06-03-5
.
This chart can be use as a “starting point” to cor-
rect the chaincase perpendicularity.
TYPICAL
1. Upper shim location
2. 50 mm long screws when installing one shim or more
3. Lower shim location
– Do not reinstall the driven pulley at this time.
AXIAL PLAY ADJUSTMENT
TOP VIEW
1. Countershaft
2. Shim position on end bearing housing side
3. Shim position on chaincase side
4. Drive axle
5. Axial play
6. Shim between sprocket and spacer
– Push the drive axle toward chaincase and take
note of the distance between the sprocket and
tunnel.
1. Distance between sprocket and tunnel
2. Drive axle pushed toward chaincase
BEARING POSITION
(A)
TOWARD
FRONT
OF VEHICLE
(B)
TOWARD
REAR
OF VEHICLE
(C)
TOWARD
BOTTOM
OF VEHICLE
(D)
TOWARD
TOP
OF VEHICLE
SHIM
LOCATION
LOWER UPPER UPPER LOWER
A01D07A
1
3
2
A01D04A
1
3
2
4
5
6
A01D08A
2
1
To Next Page
Loading...
