9-2
PDW-700/V1 (E)
9-1-4. Notes on Adjustment
. Some adjustments of the Electrical Alignment require
menu to be used.
Put the unit into the SERVICE mode to display the
SERVICE menu. (Refer to “4-9. SERVICE Menu”.)
. Be sure to turn off the power before extending the plug-
in board using the extension board.
. Before starting adjustment, set the main POWER switch
of Camcorder to ON, then be sure to allow for about 10-
minute warm-up time.
9-1-3. Switch Setting before Adjustment
Before performing adjustment, set switches and menu as
follows.
Inside panel:
GAIN switch → L (0 dB)
OUTPUT/DCC switch → CAM/OFF
WHITE BAL switch → PRST
Front panel:
SHUTTER switch → OFF
Filter knob → 1
Lens:
LENS → MANU
IRIS → C (CLOSE)
Menu:
MENU: OPERATION
PAGE: GAIN SW
ITEM: GAIN LOW → 0 dB
ITEM: GAIN MID → 6 dB
ITEM: GAIN HIGH → 12 dB
MENU: OPERATION
PAGE: OUTPUT 1
ITEM: SDI OUT 1 SELECT → HDSDI
MENU: PAINT
PAGE: SW STATUS
ITEM: GAMMA → ON
ITEM: KNEE → ON
ITEM: WHITE CLIP → ON
ITEM: DETAIL → ON
To Next Page
Loading...
