2-1
PDW-700/V1 (E)
Section 2
XDCAM Web Site
2-1. XDCAM Web Site Overview
Operations such as confirming the settings of the camcorder and upgrading the firmware can be performed via the network
connector.
The XDCAM website consists of the following menus.
Status menu
. Device Information
. Hours Meter
. Software Version
Disc menu
. Disc Properties
. Thumbnails
Maintenance menu
. Network
. Account
. Software Update
. License Registration
Connecting to XDCAM Website
Tools/Equipment Required
. Personal computer (referred to as PC hereafter)
. Network cable (crossover or straight-through)
Setting the Camcorder
. Change the ETHERNET/USB of power save item in OPERATION menu to ENABL (refer to Operation manual)
. Set the network item in MAINTENANCE menu (refer to Operation manual)
Procedure
1. Connect the camcorder to the host PC using one of the following ways. (Refer to Connection Diagram.)
. Directly connect the camcorder to the host PC.
. Connect the camcorder to the host PC through a network device (such as a hub).
2. Start the web browser of the host PC. Enter “http://192.168.1.10” in the Address bar. (The underlined part is the IP
address of the unit.)
n
Use Internet Explorer for the web browser of the host PC.
Other web browsers may not function correctly.
3. Enter “admin” for User name and “pdw-700” for Password, and then click “OK”.
n
User name and User password can be changed on the Account page.
4. The XDCAM top page appears. Click a menu you want to browse on the left frame.
To Next Page
Loading...
