1-48
PDW-700/V1 (E)
1-11. Firmware/Software
1-11-1. EEPROM/FRAM List
Board Ref. No. Type Saving data Action to be taken
name when replacing
AT-177 IC308 FRAM All setting values of the menu, ABB/AWB adjustment data Replacement not required
CN-3005 IC2 EEPROM Model name, Serial No., Model code, MAC address Required
Refer to “7-8-3. CN-3005 Board”.
DCP-44 IC8 EEPROM Backup data of the CN-3005 board, DCP board adjustment Replacement not required
value in the production factory
SY-355 IC300 EEPROM *1 Not required
IC507 FRAM *2 Not required
FP-157 IC913 EEPROM Audio A/D adjustment DSP multiplication value, Audio D/A Required
adjustment DSP multiplication value, Power voltage Refer to “7-8-6. FP-157 Board”.
calibration value, SIDE VOLUME adjustment value
SE-857 IC4 EEPROM Adjustment data, digital hours meter data Required
Refer to “8-2-3. Adjustment After
Replacing the SE-857 Board”.
DR-617 IC20 EEPROM Backup data for the CN-2947 board, PA board adjustment Replacement not required
value in the production factory, CCD block specific data
PD-118 IC3 EEPROM PD-118 board adjustment value in the production factory Required
*1 : Hours Meter, Operation Hours (Back Up)
Serial No. Model ID (same as the data saved in EEPROM on the CN-3005 board)
Network setting (same as the data saved in FRAM on the AT-177 board)
*2 : Hours Meter, Operation Hours, System Information (same as the data saved in FRAM on the AT-177 board)
GUI relevant data, NRT Metadata relevant data, Error Log, Salvage information
To Next Page
Loading...
