3-2
PDW-700/V1 (E)
3-2. Error Code List
3-2-1. Main Code and Sub Code
Main Code
An error code is provided in combination of 2-digit main code and 3-digit sub code.
XX-XXX
Main code Sub code : For details of sub codes, refer to respective error tables.
Main code Main error description
0X Optical drive control errors, device errors
. 02: Optical devices (LD, LCD)
. 03: Optical drive two-axis (FCS, TRK)
. 04: Optical drive seeking
. 06: Optical drive SA actuator
. 08: Optical drive spindle
20 Loader assembly errors
3X Optical drive sensor system errors
5X Read data errors
6X Startup errors
91 Interface errors between CPU and peripheral devices
92 Synchronization system errors
95 Video/audio signal processing device errors
If multiple errors occur simultaneously
The highest-priority error is displayed.
When a higher-priority error is cleared, the following-priority error code is displayed.
Protection Mode
When this unit detects an error, it enters a protection mode to prevent the cartridge disc, optical drive, and
other components from damage or failure.
The protection mode depends on error status. When a cartridge is inserted, press the EJECT button and
remove the cartridge.
The cartridge may not be ejected even after the EJECT command has been received depending on error
status. In this case, turn the unit power OFF and ON.
To Next Page
Loading...
