Sony CBK-HD01 - Page 90

3-8
PDW-700/V1 (E)
(Continued)
Main Sub Time data Maintenance Drive Description
code code display logger logger
95 503 ← OOOptical drive’s BDC (IC300/DR-606 board) error is detected during initial
check.
507 ← XOAdjustment data cannot be read from EEPROM in optical block assembly.
508 ← OOHours meter data cannot be read from EEPROM in optical block assem-
bly.
509 ← OOAdjustment data cannot be read from optical drive’s EEPROM (IC4/
SE-857 board).
50A ← OOHours meter data cannot be read from optical drive’s EEPROM (IC4/
SE-857 board).
50C ← OOOptical drive’s SYS PE (IC700/DR-606 board) configuration error is
detected.
50F ← OOCannot access SDRAM (IC301/DR-606 board) for Optical driver’s BDC
(IC300/DR-606 board).
513 ← OOOptical drive’s BDC (IC300/DR-606 board) cannot set the SDRAM mode.
51C ← OOOptical drive’s BDC (IC300/DR-606 board) cannot reset free-run by SYS PE
(IC700/DR-606 board).
52C ← OOAuto setting by SYS PE (IC700/DR-606 board) is disabled with power
control of optical drive’s BDC (IC300/DR-606 board).