Loading Material Connecting Material Coil Box To Printer
Page 115
© Copyright 2021 Stratasys. All rights reserved.
Figure 12: Material Ports
9. Material begins to load to the liquefier tip within the head. The pathway displayed between
the Material Status Icon and the corresponding Head Status Icon becomes highlighted to
indicate load progress (see Figure 32 (page 35)).
10. When filament reaches the head, it enters the liquefier tip and begins to warm to the
material operating temperature (automatic - based on material coil box memory chip data).
This step also sets the oven temperature to the correct value for the material being loaded
11. Once the tip is within three degrees of the set point temperature the head moves to the
purge area and the tip purges a small amount of material.
If during the purge process an error occurs, the corresponding LED will display solid
red.
To Next Page
