Stratasys F770 - Calibration and Adjustments; Tip Calibration

Printer Status Materials Status
Page 139
© Copyright 2021 Stratasys. All rights reserved.
portion of the Display Area of the page. Touching one of these icons on the screen will open
that head’s Head Details page (see “Viewing Head Details” (page 64)). Odometer information
for the selected head is displayed within the right half of the Head Details page (see
Figure 26 (page 65)).
The Head Status Icons can become yellow or red based on the head’s odometer (see
Table 6 (page 62)). An accompanying warning/error notification will be displayed within the
Materials page when a head is in a warning or error state resulting from odometer related
information (see “Head Warnings” (page 243) and “Head Errors” (page 243)). An icon with
yellow coloring indicates a warning, reminding you that the head is reaching its odometer limit.
An icon with red coloring indicates an error, reminding you that the head has exceeded its
odometer limit. You can continue using a head which has exceeded its odometer limit, but it is
highly recommended that you change the head as part quality will be unpredictable. Warning
and error states will be will indicated on the User Interface until the head is replaced, and you
will be required to acknowledge the notification associated with these states prior to the start of
each build.
Materials Status
The current status of each of the material coil boxes connected to the printer can be viewed via
the Materials page. To locate this information:
1. Press the Materials button within the Navigation Menu; the Materials page will be
displayed.
2. The Display Area of this page contains two “Material Status Icons” (page 27). The left icon
pertains to the printer’s model material while the right icon pertains to the printer’s support
material. The number displayed within the top of the icon indicates which material slot the
material coil box is connected to (1 or 2). The colored bars (displayed within the center of
the icon) and percentage (displayed at the bottom the icon) indicate the current volume of
material in the box. The name of the type of material in the box is displayed at the bottom of
the icon.