Stratasys F770 - Tools Page Menu

Working with the Tools Page Tools Page Menu
Page 77
© Copyright 2021 Stratasys. All rights reserved.
Tools Page Menu
The Display Area of the Tools page contains 6 buttons. With the exception of the Light button,
pressing each of these buttons will open an individual page containing printer information that
can be viewed as well as printer settings and preferences which can be configured.
Table 12: Filament Pathway States
Icon State Description
Settings
Pressing the Settings button opens the Settings page. From this page you can
configure and adjust several of the printer’s default settings. See “Settings”
(page 79) for details.
Calibration
Pressing the Calibration button opens the Calibration page. From this page you
can preform various printer calibration procedures. See “Calibration” (page 90)
for details.
Maintenance
Pressing the Maintenance button opens the Maintenance page. From this
page you can perform various printer maintenance procedures. See
“Maintenance” (page 93) for details.
Network
Pressing the Network button opens the Network page. From this page you can
configure the printer’s network connection. See “Network” (page 97) for details.
Power
Pressing the Power button opens the Power page. From this page you can
shutdown or restart the printer. See “Power” (page 103) for details.
Light
The Light button is the only option within the Tools page that does not open a
new page after being pressed. Instead, the Light button allows you to turn the
oven light ON and OFF. An indicator within the upper-left corner of the button
displays the current state of the oven light (ON or OFF). See “Light” (page 104)
for details.