Stratasys F770 - Finding a Remedy

Warnings and Errors Warnings at Build Start
Page 234
© Copyright 2021 Stratasys. All rights reserved.
Warnings at Build Start
Model material does not match selected job
• The model material currently installed does not match the model material configuration of
the selected job.
• Correct condition - unload incorrect model material and load the correct model material for
the selected job. See “Unloading Material” (page 118) and “Loading Material” (page 107)
for instructions.
Support material does not match selected job
• The support material currently installed does not match the support material configuration
of the selected job.
• Correct condition - unload incorrect support material and load the correct support material
for the selected job. See “Unloading Material” (page 118) and “Loading Material”
(page 107) for instructions.
Insufficient model material for part build
• The amount of model material currently installed in the printer is not sufficient for the
selected build.
• Correct condition - connect a material coil box to the printer that contains a sufficient
amount of model material. See “Loading Material” (page 107) for instructions.
Insufficient support material for part build
• The amount of support material currently installed in the printer is not sufficient for the
selected build.
• Correct condition - connect a material coil box to the printer that contains a sufficient
amount of support material. See “Loading Material” (page 107) for instructions.
Order new model head
• The model head has reached 1350 build hours, and is near its odometer limit. Build hours
are available within the head’s Head Details page (see “Viewing Head Details” (page 64)).
• Correct condition - you are still able to build using this head, but part quality may be
affected. Once the head’s odometer limit is reached, you will be prompted to change the
head (see “Head Replacement” (page 121)).
Order new support head
• The support head has reached 1350 build hours, and is near its odometer limit. Build hours
are available within the head’s Head Details page (see “Viewing Head Details” (page 64)).
• Correct condition - you are still able to build using this head, but part quality may be
affected. Once the head’s odometer limit is reached, you will be prompted to change the
head (see “Head Replacement” (page 121)).
Replace model head
• The model head has reached 1500 build hours (odometer limit). Build hours are available
within the head’s Head Details page (see “Viewing Head Details” (page 64)).