Basic Job Build Tasks Pausing a Build
Page 129
© Copyright 2021 Stratasys. All rights reserved.
• While the printer is building, various pause and abort related warnings may be displayed.
Some of these warnings may be due to a manual pause or abort, while others may be the
result of the printer automatically pausing or aborting a build. Depending on the severity of
the warning you may or may not be able to resume building.
See “Warnings and Errors” (page 233) for a detailed list of the warnings you may encounter,
and instructions on how to correct them.
Pausing a Build
During a build the Pause button within the Build page becomes selectable (see “Pause Button”
(page 52) for details). The printer can pause automatically, or be manually paused using this
button:
• An automatic pause occurs when a material coil box runs out of material, a failure is
detected, etc.
• A manual pause occurs whenever the Pause button is pressed.
When the printer is directed to pause:
1. The current toolpath is completed, the Z stage is lowered slightly, and then the head
assembly is parked. "PAUSED" is displayed within the Build Status Display (see Figure 23).
If an automatic pause occurs, text will be displayed within the Notifications Display portion
of the Build Page. Touching the text on the screen will open a dialog indicating the reason
for the pause condition (i.e. empty material coil box). Correct this condition and then press
the Close button to exit the dialog. (See “Build Pause Warnings” (page 239) for a list of
pause related warnings/errors and resolution instructions.)
To Next Page
Loading...
