Working with the Materials Page Viewing Head Details
Page 65
© Copyright 2021 Stratasys. All rights reserved.
To close this page and return to the main Materials page, press the Back button within the
header of the page.
Figure 26: Head Details Page
Head Maintenance
Pressing the Maintenance button within the Head Details page will open the Head
Maintenance page. The buttons within this page will allow you perform a variety of head
maintenance functions. The buttons displayed in the menu within the right half of the screen
will vary depending on whether the Enable button has been pressed. After pressing the
Maintenance button the button will toggle and instead display the Details button. Pressing the
Details button will close the Head Maintenance page and return you to the Head Details page.
Enable
Pressing the Enable button puts the corresponding head into a maintenance state when the
top cover has been opened. Before you can perform any of the head maintenance functions
available within the Head Maintenance page, you must put the head into this state by pressing
the Enable button. After pressing the Enable button, the menu will refresh and display buttons
Warning/error
information
displayed here
To Next Page
Loading...
